Wednesday, June 14, 2023

URRF 9 flight Log - Potter New York

My Flights -  

Friday June 9th, 2023

Launch #1

Wildman Punisher (3 inch diameter) first flight on an Aerotech I357 Blue Thunder EX built motor - I cut and drilled the grains and the delay element and assembled the motor using an EMK360 kit. 

The altimeter was an Eggtimer Quantum configured for auto-arm, and mains deployment at 500 feet.

Three m2 shear pins were installed on the nose cone. No shear pins were used on the airframe.

The rocket was setup with a main black powder charge of 1.8g, and an apogee charge of  1.5g  

Boost was perfect with a recoded apogee of  1923 feet.  Apogee charge fired as expected at 1911 feet.

Descent rate on the drogue was 60 ft/second and  then the main charge fired at about 411 feet with a descent rate on the main chute of 22 feet/second.

No tracker onboard and rocket was visible through the boost and recovery phases.



Saturday June 10th, 2023

Launch #1

Loc Wolverine on a CTI J354 configured for 12 second delay. Estimated Altitude was 3780 feet using open rocket.

Rocket had a runcam 2 4k onboard and a jolly logic chute release set for 600 feet.

Boost was good, deployment occurred at apogee. Chute release performed as expected.  

Rocket was visible through the entire boost and recovery phase.

Included a eggfinder mini GPS tracker and used my new Eggfinder LCD receiver as well as the Eggfinder BT receiver. Neither worked correctly, all indicated the completely wrong direction to recover the rocket.


Launch #2

First flight of the Loc Big Nuke 3E (Children of Atom edition) on a Aerotech J415.   RSO weighed the rocket at 14 lbs and 15 oz - which is much heavier than the simulation weight.

Simulated altitude was 3600 feet but the actual recorded altitude was 2780 feet (848 m).

The rocket was configured with a Eggtimer classic as the primary flight controller, and an  Altus Metrum easy-mini as the backup flight controller. 

I incorrectly configured the Eggtimer classic so while it did record the flight data, it did not fire any recovery charges.

I also incorrectly configured the Easy-mini - I thought I set the main charge altitude to 500 feet but I actually set it to 500 meters. The mains were deployed at a high altitude and it was windy so I had to walk a couple of miles to retrieve the rocket.








Sunday June 11th, 2023

Loc Wolverine on a CTI J335 Red with an estimated altitude of 3300 feet.  Chute release was set to 600 feet but for some reason the main chute came out at apogee.  Winds were low so this had minimal effect on the recovery.




===============================================================

Chip's Flights -


URRF 2023 - Potter NY - June 9-11


Friday June 9


Peacock - F37 6 sec delay was perfect.  Open rocket called for 4 sec.

Parachute did not hang up inside this time.

 

LOC Stovi H128 HEADS UP!  That thing was gone quickly.  Need better glasses. Good recovery.  Finally saw it coming down when it was nearly all the way down.



Saturday June 10


Bull Pup - I245G-10 Jollylogic Chute Release at 500’ Boost and recovery, did not see it for most of the flight.


Cherokee 3XE - J330 - RRC2+ set to 500’ - No main Again! No altitude reported.  Drogue charge fired, main charge did not, chute did not deploy.  Nose cone was off but not due to black powder charge.  Chute could not pull itself from the deployment bag - far too tight. Recovery harnesses were a tangled mess!  Upon inspection, discovered that wires on altimeter were loose. Failure likely due to power interruption during flight.  Altimeter later tested with LED’s and Shop Vac and found to be functional.  Going to add another altimeter and go again. Used 2 grams on drogue and 2.5 on main.


Sunday June 11


Slugbuster - J330 motor - reached an altitude of 1644’. Without sufficient eyewear, no sense in sending this higher than 2000 ft. At least I saw it for the entire duration. Open Rocket simmed to just over 2000’ - need to double check the weight. 




Wednesday, June 15, 2022

Ohio Storm Damage June 13th, 2022

 On June 13th a terrible storm hit southern Wayne county in Ohio.   Below are some images of some of the damage.


Drone footage of the downed trees


Smyser Road is closed



Pile of fallen trees


Trees Snapped off


Monday, June 28, 2021

Another 4K Rocket Launch Video

The Brutus again - this time on an Aerotech I285 Redline motor. The motor took too long to light and therefore the ejection charge was too early. (Seems to be an ongoing issue with the redline motors). 

The rocket was not damaged.



Sunday, June 6, 2021

Mid Ohio Rocket Launch photos

Don't know whose rocket but I like the photo.




 My Loc-Precision Wolverine on an I366 motor that fired late and therefore the delay burned through and the ejection charge fired early causing a massive tear in the airframe.   Everything looks good here though.

Rocket Launch Video 4K

 Here is the on-board video from the Runcam2 4K camera.  


The camera is Mounted in a 3D printed plastic housing attached to the upper half of the rocket.  The rocket is a 20+ year old Rocket R&D Brutus.  This rocket is no longer available.  https://www.fusionrocket.biz/ did offer a version about a year ago or so but I think it is not available as of June 2021.

 The motor is an Aerotech I161 with a 10 second ejection delay. Maximum altitude estimated to be about 640 meters (2100 feet).


The Runcam2 4k  caused some trouble.  It seemed to stop recording for no apparent reason.  The current working hypothesis is that it turned off due to overheating when recording at 4K.

We are running tests to confirm this.  

Update #1: Unable to reproduce the problem so far. I have recorded at least an hour of video in direct sunlight with no problems.  The camera gets very warm but it doesn't turn off. 

Update #2: The microSD cards used are rated up to 20 MB/second write speeds.  This is too slow for 4K video.  I have new microSD cards rated to 90 MB/seconds.


Monday, May 3, 2021

Rocket Launch

LAUNCH!



 Rocket R&D Brutus flying with an Aerotech I-357 motor.  On-board Eggtimer Quantum altimeter recorded 2160 feet as the altitude. Below is the raw filtered data from the altimeter.